5 Series E34 525td (M51) TOUR
Heat the rear case section in the area near the output shaft
bearing to approx. 80
°
C (hot air blower). Install bearing, using, if
necessary, special tool 23 2 450 and handle 00 5 500 until
securely driven into place.
Clean screws and threaded bores.
Install retaining plate (2) and oil scraper plate (1).
Coat screws with Loctite 243 screw locking varnish and screw in.
Tightening Torque,
refer to Technical Data 23 11 17AZ.
Bearing on countershaft:
- Hex screw with washer -
Clamp the layshaft bearing in a vise with two protective pads (3).
Note:
Screw (1) has a left-hand thread.
Unscrew bolt (1).
Take off washer (2).
Note:
Instead of the hex screw (1) and the washer (2), a Torx screw
is fitted!
- Torx screw -
Clamp countershaft in a vise with protective jaws.
Note:
Screw (1) has a left-hand thread.
Unscrew bolt (1).
RA Replacing bearings on all gearshafts (S5D 200G/ 250G)
BMW AG - TIS
23.01.2013 07:12
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
