5 Series E34 525td (M51) TOUR
Remove all three bolts which connect the torque converter to the
drive plate using special tool 24 1 110.
To do this, rotate engine using front central screw in stages of 120
°
.
Installation:
Install screw with special tool 24 1 110 and tighten down
with torque wrench.
Tightening torque,
refer to Technical Data 24 40 1AZ.
Caution!
Only use original bolts.
Preassemble special tool 24 5 300 suitable for the 5 HP 18
transmission as marked.
Support transmission with fixture 24 5 300 in conjunction with
lifting gear 00 2 020.
Engine M50:
Removing end fire wall,
refer to 61 61 270.
Unscrew injection pipe cover (1).
Support rear engine before unscrewing the cross member.
Mount special tool 11 0 030 from above through the intake
manifold in the holder on the crankcase.
Mount special tool 00 0 200 and hook it in.
Tighten spindle (2).
RA Removing and installing automatic transmission (A5S 310Z)
BMW AG - TIS
23.01.2013 07:16
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
