5 Series E34 525td (M51) TOUR
Installation:
Install thrust washer (3).
Coat new shaft seal (2) with automatic-transmission oil.
Drive in shaft seal with special tool 24 4 100.
Press out seal and needle bearing with special tool 00 5 500
and 23 1 270 on hydraulic press.
Installation:
Insert seal (1) in pump housing.
Press in needle bearing (2) with special tool 24 1 010.
Clutches (A/B/C):
Fit special tool 24 1 270 to the input shaft and secure with pin.
Lift out drive unit with clutches (A/B/C) using a workshop crane
and place on 2 wooden blocks.
RA Dismantling and assembling automatic transmission (A5S560Z)
BMW AG - TIS
23.01.2013 07:17
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 8 -
