5 Series E34 525td (M51) TOUR
Installation:
The impulse spring on the top clutch housing must be located
in centre of bore for impulse sensor.
Installation:
Lower drive unit with clutches (A/B/C) into transmission case
with a workshop crane.
Twist disc carrier D (1) to and fro with a screwdriver until it
engages fully in discs of D brake.
Place drive unit with clutches (A/B/C) on its head.
Remove axial needle bearing (1).
Installation:
Secure axial needle bearing (1) with Vaseline.
Coat the rectangular rings (2) with Vaseline and push them
into the grooves.
Caution!
If the rectangular rings (2) are too high, they can be damaged
during installation.
Bend back retaining tabs with special tool 24 1 310.
RA Dismantling and assembling automatic transmission (A5S560Z)
BMW AG - TIS
23.01.2013 07:17
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 9 -
