5 Series E34 525td (M51) TOUR
Press special tool 24 0 011 (dial gauge holder) with dial gauge
from special tool 24 0 010 over input shaft spline and secure
with retaining screw.
Determine axial clearance by pulling on input shaft.
Nominal clearance = 0.10 ... 0.30 mm
If value is not as specified, fit a thinner or thicker spacer as
required.
Fit new seals (1) to all screws and tighten down.
Tightening torque, refer to Technical Data 24 31 3AZ
RA Replacing oil pump housing
BMW AG - TIS
23.01.2013 07:28
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -