5 Series E34 525td (M51) TOUR
24 40 005
Removing and installing/replacing torque
converter (A4S 270R/ 310R)
Remove transmission,
refer to 24 00 025 .
Carefully pull torque converter out of primary pump with special
tool 24 4 000.
Note:
Escaping automatic transmission fluid.
Install torque converter:
Important!
Make sure converter bearings and seal are not damaged
while guiding in. Insert torque converter as far as stop.
Push torque converter through radial sealing ring up to first detent
position on transmission input shaft.
Manually push and turn the torque converter into the converter bell
housing until the recess of the converter hub rests in the drive
plate of the pump wheel and the torque converter perceptibly
slides in.
The torque converter is properly installed when the distance
between the contact surface of the threaded converter fitting on
the torque converter and the end face of the converter bell
housing is approx. 31 mm.
RA Removing and installing/replacing torque converter (A4S 270R/ 310R)
BMW AG - TIS
23.01.2013 07:36
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
