5 Series E34 525td (M51) TOUR
33 12 526
Replacing bearing for input bevel gear
(Type M) - final drive removed -
Removing final drive, included in MF (microfiche) Repair
Instructions, model-dependent, from '85,
refer to 33 10 010.
Secure final drive to special tool 33 1 010.
Drain off fluid. Take off case cover.
Installation:
Replace seal.
Tightening Torque,
refer to Technical Data 33 11 1AZ.
Topping up oil,
Oil quantity,
refer to Technical Data.
Oil grades,
refer to Operating Fluids specifications.
Press off drive flange with pry bar.
Installation:
Before fitting the drive flange, the round wire circlip (1) must
be placed in the groove of the differential housing in such a
way that both ends of the round wire circlip are recessed.
This prevents lateral bending of the ring.
Press in drive flange by hand and turn slightly until wire snap ring
is heard to engage.
Replace stretched snap rings.
RA Replacing bearing for input bevel gear (Type M) - final drive removed -
BMW AG - TIS
23.01.2013 07:44
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
