5 Series E34 525td (M51) TOUR
Remove crown wheel (cold).
Installation:
Clean tapped bores thoroughly (tapper).
Heat plate spring to max. 100
°
C (thermo-chrome pin).
Mount crown wheel with two locally manufactured staybolts for
guiding.
Install new screws with Loctite No. 270 and tighten down in
sequence (1 ... 10).
Tightening torque,
refer to Technical Data 33 12 1AZ.
Remove taper roller bearing from recesses on final drive housing
with standard extractor tool in conjunction with special tool
33 1 305 (pressure piece).
Installation:
Press-fit new taper roller bearing inner races cold with special
tool 33 1 003 (sleeve).
RA Replacing drive pinion with crown wheel (Type G) - final drive removed -
BMW AG - TIS
23.01.2013 07:44
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 7 -
