5 Series E34 525td (M51) TOUR
Punch mark both bearing caps.
Unscrew and remove both bearing caps.
Caution!
Don't mix up bearing caps and spacers.
Secure spacers on bearing cap with a piece of wire, if
necessary.
Installation:
Tightening torque, refer to Technical Data
Final drive housing bearings and backlash are adjusted with shims
(1).
Check O-ring (2), replacing if necessary.
Remove complete final drive housing.
Caution!
Don't bend the pulse spider.
Remove lockplate.
Unfasten nut (1) and brace with special tool 23 0 020.
RA Replacing input bevel gear and crown wheel (Type M) - final drive housing remove
BMW AG - TIS
23.01.2013 07:44
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
