5 Series E34 525td (M51) TOUR
Installation:
Press fit pulse generator wheel with special tool 33 1 358
(pressure sleeve).
Remove crown wheel (cold).
Installation:
Clean tapped bores thoroughly (tapper).
Heat plate spring to max. 100
°
C (thermo-chrome pin).
Mount crown wheel with two locally manufactured staybolts for
guiding.
Install new bolts with Loctite No. 270 and tighten in order of (1 ...
10)
Tightening torque and torque angle,
refer to Technical Data
Extract taper roller bearing on final drive housing with special tool
33 1 300 (extractor).
RA Replacing input bevel gear and crown wheel (Type M) - final drive housing remove
BMW AG - TIS
23.01.2013 07:44
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 10 -
