5 Series E34 525td (M51) TOUR
33 13 611
Replacing differential bevel gears (Type M) -
final drive housing removed -
Removing final drive housing: operation included in "Replacing
drive pinion with crown wheel",
refer to 33 12 551
Press off pulse spider.
Installation:
Press fit pulse generator wheel with special tool 33 1 358
(union ring).
Remove ring gear (cold).
Caution!
If bearings were replaced, do not install crown wheel until
after friction torque has been determined, similar to replacing
bearings on final drive housing,
refer to33 11 731.
Installation:
Clean tapped bores thoroughly (tapper).
Heat plate spring to max. 100
°
C (thermo-chrome pin).
Mount ring gear with two locally manufactured staybolts for
guiding.
Installation:
Install new screws with Loctite No. 270 and tighten down in
sequence (1 ... 10).
Tightening torque and torque angle,
refer to Technical Data
RA Replacing differential bevel gears (Type M) - final drive housing removed -
BMW AG - TIS
23.01.2013 07:45
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
