5 Series E34 525td (M51) TOUR
Press out final drive shaft with special tool 33 1 470 (feed
mandrel) from countersunk side.
A = Pressing out direction
E = Pressing in direction
Turn out differential bevel gears with drive flange.
Remove differential side gears with diaphragm springs and shims.
Install both differential side gears with diaphragm springs (1) and
shims (2).
Curved surface of diaphragm springs (1) faces differential case.
Center differential side gears with the drive flange.
Install special tool 33 1 306 (pressure piece) on one side.
Screw in special tool 33 1 441 (threaded plate) with special tool
33 1 430 (spindle).
Tighten special tool bolt to spread differential side gears so far
apart, that the drive flange can just barely be turned.
RA Replacing differential bevel gears (Type M) - final drive housing removed -
BMW AG - TIS
23.01.2013 07:45
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
