5 Series E34 525td (M51) TOUR
Note:
Using the "Roll Out 2000" system (sourcing reference: BMW
Workshop Equipment and Planning Documentation) minimizes
paintwork and ergonomic damage as well as damage that is
hazardous to health.
Warning!
Follow safety instructions for working on cars with airbag
systems (risk of injury).
Important!
Take care when handling sharp-edged tools and cutting wire
(risk of damage to head airbag).
Important!
Always keep both suckers dry and clean to ensure their
optimum adhesion on the windscreen.
Lubricate coil if interlock rattling becomes too loud.
Always wear protective goggles and gloves for your own
safety.
Preparatory work:
-
To avoid paintwork damage, tape off working area over large
area at outlet of wire starter (2) with fabric adhesive
tape (1)
-
Cut off required length (A) from cutting wire
(A) = Window diagonal x 4
-
Check whether wire can get caught on rivets or retainers; if
necessary, insert guide needles in bonding joint and guide
cutting wire past
RA Removing windscreen with "Roll Out 2000"
BMW AG - TIS
23.01.2013 08:01
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
