5 Series E39 520i (M52TU) SAL
Close rear lid, measure and note down gap to tail panel.
Position lower section of rear lid lock higher or lower so that a gap
of min. 5.0 mm between rear lid and tail panel is obtained.
Check adjustment and repeat if necessary.
4. Open trunk lid.
Screw in detent buffer until left and right sides of trunk lid locate
against detent buffers when closed.
5. Gently twist ejector in detent buffers to right with Phillips
screwdriver. This unlocks the detent buffers, enabling ejector to
emerge.
RA Adjusting trunk lid to fit
BMW AG - TIS
05.02.2013 08:24
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -