5 Series E39 525tds (M51) TOUR
Remove retaining disc (1) and disconnect lever.
Unfasten plug connection (1). Unfasten screws.
Installation:
Note installation position of accelerator sensor, also noting
position of levers (1 and 2).
Caution!
Lever (1) is factory-set and must not be disconnected. If the
lever (1) has been removed, the entire accelerator sensor
must be replaced!
Installation:
Install bracket (1) with weld-in nuts.
RA Removing and installing/replacing accelerator sensor (M51)
BMW AG - TIS
20.02.2013 03:13
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -