5 Series E39 528i (M52) SAL
33 32 064
Removing and installing or replacing left or
right swinging arm
Caution!
Pull retainer off air supply unit to ensure that accidental
feedback control of the system cannot occur.
After assembly, perform rear wheel alignment
check/adjustment.
Remove wheel,
refer to 36 10 300.
Unclip cable for ABS pulse generator.
If necessary, unfasten control rod for level control system on the
swinging arm.
Remove stabilizer link (1).
Installation:
Replace nut (3). Use washer (2).
Tightening Torque,
refer to Technical Data 33 55 2AZ.
Mark position of eccentric screw on rear axle carrier with colored
spots.
This simplifies the subsequent task of adjusting toe when the old
swinging arm is reinstalled.
RA Removing and installing or replacing left or right swinging arm
BMW AG - TIS
21.02.2013 20:28
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -