5 Series E39 528i (M52) SAL
37 14 511
Replacing front ride-height sensor
Important!
Read and comply with notes on protection against
electrostatic damage (ESD protection).
After installation:
•
Check headlight adjustment, correct if necessary
Pull off plug (1).
Release nut (2) and disconnect control rack.
Release screws (3) and remove ride-height sensor.
Installation:
Lever (4) points backwards.
Tightening torque 37 14 6AZ/7AZ
.
Note:
When replacing the control rack, unfasten tab (1).
Installation:
The bracket must be situated between both cast lugs (2). Ensure
tab (1) is correctly located.
RA Replacing front ride-height sensor
BMW AG - TIS
21.02.2013 21:59
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
