5 Series E39 540i (M62) SAL
Coat joint between engine block and timing case cover with
Drei Bond 1209 (refer to BMW Parts Service).
Check that dowel sleeves are undamaged and correctly located.
Place new cylinder head gasket in position.
Put the cylinder head on. Install new cylinder head bolts. Do not
wash off bolt coating.
Note:
Use special tool 00 9 120 as a torsion angle bracket.
Tighten down the cylinder-head bolts in order 1 ... 10.
Tightening Torque,
refer to Technical Data 11 12 8AZ.
RA Removing and installing left cylinder head (M62 VANOS from 9/98)
BMW AG - TIS
20.02.2013 11:54
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
