5 Series E39 M5 (S62) SAL
Note:
(3)
Install stop disk for collar bearing
(in engine block).
(4)
Install stop disk for collar bearing
(in main bearing cap).
Caution!
Check installation direction. Lubricant groove must be facing
crankshaft.
Insert stop disks for collar bearing on both sides between
crankshaft and engine block at main bearing 5.
Align thrust washers with contact face of main bearing caps.
Note:
Main bearing caps 1 and 2 are marked with punched
numbers.
Main bearing cap 3 is marked with three notches.
Main bearing caps 4 and 5 are not marked.
RA Replacing all crankshaft main bearing shells (S62)
BMW AG - TIS
21.02.2013 07:04
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
