5 Series E39 M5 (S62) SAL
Align radial piston pump to driver on spline hub.
Note:
Picture shows a schematic representation.
Press buttons 2 and 4 on special tool
12 6 050 . The solenoid
valves are activated and the air can escape from the hydraulic
pistons of the VANOS adjustment unit.
Simultaneously push on VANOS adjustment unit until O-rings of
VANOS adjustment unit rest against timing case cover.
Caution!
If this position is not reached, realign position of radial piston
pump to driver.
Tighten down screws on VANOS adjustment unit carefully and
evenly in 1/2 turn steps.
Disconnect special tool 12 6 050 and special tool 12 6 410
and remove.
Reconnect plug connections of solenoid valves and clip into
holder.
RA Removing and installing, sealing/replacing left VANOS adjustment unit (S62)
BMW AG - TIS
21.02.2013 15:26
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 7 -
