5 Series E39 M5 (S62) SAL
12 62 500
Replacing coolant temperature sensor (DME)
(S62)
Interrogate fault memory of DME control unit.
Switch off ignition.
Remove and install left intake hose,
refer to 13 54 250.
Disconnect plug connection (1).
Remove temperature sensor (2).
Tightening torque,
refer to Technical Data 12 62 3AZ.
Note:
Top up with coolant, vent cooling system and check for leaks,
refer to 17 00 039.
Use only recommended coolant,
refer to BMW Operating Fluids MG17.
Interrogate fault memory of DME control unit. Check stored
fault messages. Rectify faults. Now clear the fault memory.
RA Replacing coolant temperature sensor (DME) (S62)
BMW AG - TIS
21.02.2013 16:20
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
