5 Series E60 545i (N62) SAL
Replace screw.
Install screw on inlet adjustment unit.
Tighten screw without play and then slacken off again by half a
turn.
Note:
Position of exhaust adjustment unit (2) to timing chain can be
freely selected.
Pull timing chain up.
Feed exhaust adjustment unit (2) into timing chain.
Press tensioner rail (3) back and fit exhaust adjustment unit (2)
onto exhaust camshaft.
Note:
If tensioner rail (3) cannot be pressed back far enough to enable
fitting of exhaust adjustment unit (2):
Remove chain tensioner.
Place chain tensioner on a level surface and compress slowly and
carefully.
Repeat this procedure twice.
Installation:
Replace sealing ring.
Install chain tensioner and tighten down.
Tightening torque 11 31 8AZ
.
Fit exhaust adjustment unit (2).
Replace screw.
Install screw on exhaust adjustment unit.
Tighten screw without play and then slacken off again by half a
turn.
RA Removing and installing/replacing inlet and exhaust adjustment units on left sid
BMW AG - TIS
22.02.2013 12:14
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -