5 Series E60 545i (N62) SAL
Get special tool kit 11 9 460 ready for securing camshafts.
Note:
Special tool 11 9 461 for securing inlet camshaft.
Special tool 11 9 462 for securing exhaust camshaft.
Special tool 11 9 463 (holder with screw).
Place special tool 11 9 461 on inlet camshaft and align inlet
camshaft so that special tool 11 9 461 rests without a gap on
cylinder head.
Fit special tool 11 9 463 , secure screw (1) in thread for oil line
and tighten down by hand.
Important!
Make sure screws of inlet and exhaust adjustment units have
been slackened off by a half turn.
Crank engine at central bolt from 45
°
before TDC position in
direction of rotation to firing TDC position.
Secure vibration damper with special tool 11 9 190 in firing
TDC position of 1st cylinder.
RA Removing and installing/replacing inlet and exhaust adjustment units on left sid
BMW AG - TIS
22.02.2013 12:14
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 7 -