5 Series E60 M5 (S85) SAL
Removing throttle valve assembly 4:
Release screw.
Tightening torque 13 54 3AZ
.
Detach lock washer (1) from actuating shaft.
Release screw connection (2) of actuating shaft. Grip screw and
turn nut in the process.
Remove screw from bore.
Installation:
-
Use screw and nut only once.
-
Only turn nut and grip screw.
-
Tightening torque 13 54 1AZ
.
Unclip pull rod (3) from throttle valve assembly 4.
Detach throttle valve assemblies 5 and 4 with actuating lever from
actuating shaft.
Removing throttle valve assemblies 1, 2 and 3:
Release screw connections (4) of actuating levers. Grip screw
and turn nut in the process.
Remove screws from bores.
Installation:
-
Use screws and nuts only once.
-
Only turn nuts and grip screws.
-
Do not tighten down nuts yet.
Detach throttle valve assemblies 1, 2 and 3 as required in
sequence with actuating lever from actuating shaft.
Installation:
Actuating lever (1) of throttle valve assembly 3 and actuating
lever (2) of pull rod for throttle valve actuator are offset approx.
180
°
to each other.
Ball ends are turned to each other.
RA Removing and installing/sealing a throttle valve assembly (S85)
BMW AG - TIS
22.02.2013 17:35
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
