5 Series E60 M5 (S85) SAL
Release screws (1).
Tightening torque 21 52 9AZ
.
Release cable tie (2).
Remove wiring harness from bracket.
Remove clutch position sensor.
Important!
Only cable ties which are resistant to high
temperatures (approx. 140
°
C) may be used to secure the
cable.
Installation:
Before installation, check correct position of O-ring (1).
O-ring must be pushed on up to flange.
When the sensors are replaced, the cable must be secured
without tensile stress.
Even when the cable tie next to the marking is being positioned.
Unscrew nuts (1).
Tightening torque 21 52 5AZ
.
Remove clutch actuator.
RA Replacing clutch actuator (GS7S47BG SMG)
BMW AG - TIS
22.02.2013 19:05
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
