6 Series 645Ci (N62) Coupe
Fit sensor gear (1) and align to groove in camshaft.
Insert screw (2) and tighten down.
Tightening torque 11 31 14AZ
.
Installing plain compression rings (1):
Important!
Plain compression rings (1) can easily break.
Carefully pull compression ring (1) apart and install from front.
Press compression ring (1) on one side into groove, install catch
on other side.
Insert inlet camshaft (1) so that cams point upwards at
cylinder 5 as shown in graphic.
Make sure bearing shells (1) of eccentric shaft are engaged in
bearing bracket.
Note:
Bearing shell (1) is guided in a groove in bearing cap.
RA Removing and installing/replacing left inlet camshaft (N62 from 9/03 and N62TU)
BMW AG - TIS
18.01.2013 05:44
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 8 -