6 Series 645Ci (N62) Coupe
Important!
Danger of mix-up:
Version up to 2/03 of cylinder bank 5 to 8:
In the version up to 2/03, the eccentric shafts are different for
cylinders 1 to 4 and 5 to 8 and must not be mixed up.
The eccentric shaft of cylinder bank 5 to 8 has the part
number 7 513 755 stamped between cylinders 5 and 6 and
has no "flat area" on the collar between cylinders 5 / 6 and
7 / 8.
Important!
Danger of mix-up:
Version up to 2/03 of cylinder bank 1 to 4:
The eccentric shaft of cylinder bank 1 to 4 has the part
number 7 513 754 stamped between cylinders 3 and 4 and a
"flat area" on the collar between cylinders 1 and 2.
Important!
Danger of mix-up:
If none of the markings described above are present, then the
eccentric shaft will be a new-version shaft.
The new-version eccentric shafts are identical parts.
Depending on the side on which the lever for the torsion spring
and the magnet wheel are fitted, the eccentric shafts are used for
cylinders 1 to 4 or 5 to 8.
Note:
Lubricate eccentric shaft at bearing positions.
Replace needle bearing (1).
Important!
Needle bearings break off very easily when installed.
Carefully press needle bearings (1) apart at split position only to
such an extent that they can be fitted over eccentric shaft.
RA Removing and installing/replacing left eccentric shaft (N62 to 9/03)
BMW AG - TIS
18.01.2013 05:57
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
