6 Series M6 (S85) Coupe
Necessary preliminary tasks:
•
M5: Release service flaps.
•
M6: Detach underbody protection.
Engine with one drain plug (up to 3/07).
Explanation of instrument displays:
1.
Oil level is OK.
2.
Oil level at minimum.
3.
Oil level too high (overfilled
≥
0.5 litres).
4.
Oil level at maximum.
5.
Rapid measurement running: oil level is being determined.
6.
A reading cannot be taken at present (engine oil
temperature
≥
70
°
).
Run engine at idle speed.
Keep pressing on-board computer button on direction indicator
lever until oil level reading can be read off in instrument display.
Press on-board computer button for longer than 3 seconds to
reset the display value.
Run engine at idle until the oil level is determined again (engine oil
temperature of
≥
70
°
C).
The required oil temperature for an engine oil change is thus
achieved.
Measurement range from minimum (3) to maximum (2) =
1 litre.
Warning!
Danger of scalding!
Open oil drain plug (1) on oil filter housing.
Tightening torque: 11 42 2AZ
.
Installation:
Replace sealing ring.
Release oil filter housing (2).
Tightening torque: 11 42 1AZ
.
Installation:
Replace all sealing rings.
RA Engine oil service (S85)
BMW AG - TIS
19.01.2013 13:03
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -