6 Series E64 635d (M57T2) CONVER
54 34 101
Removing and installing complete EH
convertible top
Special tools required:
•
54 3 110
Necessary preliminary tasks:
•
Remove side trim upper section at rear
•
Remove outer window cavity cover strip
•
Remove convertible top compartment lid
•
Remove kinematics box
Before removing convertible top, mark position of main bearing in
relation to body.
When installing convertible top, align main bearing to markings.
Measure distance between retaining plate and main bearing for
convertible top on left and right and if necessary carry over
measurement to new convertible top.
This roughly determines the longitudinal adjustment.
Installation:
If necessary, adjust distance for longitudinal alignment of
convertible top.
Check gap dimensions.
RA Removing and installing complete EH convertible top
BMW AG - TIS
03.02.2013 04:51
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
