6 Series E64 645Ci (N62) CONVER
Detach plug (1) from sensor.
Unfasten screws.
Tightening torque 23 00 1AZ
.
Important!
Do not allow the transmission to hang off from the
transmission input shaft as this will deform the clutch plate.
Installation:
Check that dowel sleeves are correctly seated.
Replace damaged dowel sleeves.
Ensure correct position of cover plate.
Installation:
Check lubrication of transmission input shaft for sticky
consistency. If grease is sticky, replace clutch plate.
Check clutch plate for friction rust in taper splines and replace
if necessary.
Remove any grease and lining abrasion from taper splines of
clutch plate by mechanical means (with a cloth).
RA Removing and installing transmission (GS6S53BZ SMG)
BMW AG - TIS
04.02.2013 06:47
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -