7 Series E38 740d (M67) SAL
11 12 106
Removing and installing right cylinder head
(M67)
Instructions for disconnecting and connecting battery,
refer to General Information MG 12.
Disconnect battery negative terminal.
Warning!
Danger of scalding!
Only perform these tasks on an engine that has cooled down.
If the coolant is not completely drained from the engine block,
coolant will enter the oil sump when the cylinder head is
removed!
The cylinder head bolts must be replaced.
Caution!
If the charge air hoses are not fitted dry and without grease,
this will result in supercharger failure.
Fit charge air hoses dry and without grease.
Removal:
Removal of cylinder head is described separately from installation.
Assembly sequence for removal and installation is different.
RA Removing and installing right cylinder head (M67)
BMW AG - TIS
10.02.2013 02:26
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
