7 Series E38 740d (M67) SAL
11 23 010
Removing and installing or replacing
vibration damper (M67)
Special tools required:
•
00 9 120
•
11 6 480
•
11 8 180
•
11 8 181
Unscrew and remove splash guard.
Remove A/C compressor drive belt,
refer to 11 28 050 .
Remove alternator drive belt,
refer to 11 28 010 .
Release screws (1) on transmission at bottom.
Tightening torque,
refer to Technical Data 24 00 1AZ .
Release screw (1).
Pull slide (2) downwards up to stop.
Hold special tool 11 8 181 on transmission.
Install and tighten down screws (3).
RA Removing and installing or replacing vibration damper (M67)
BMW AG - TIS
10.02.2013 02:38
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
