7 Series E38 740d (M67) SAL
Caution!
If engine oil (1) has entered the coolant, it must be
completely soaked up with a clean cloth or blotting
(absorption) paper.
Installation note:
-
Remnants of engine oil and coolant must be removed
from blind tapped holes.
-
Coolant and engine oil must be removed from
cavities (2) in the V-area.
-
Clean sealing surfaces.
Unfasten screws.
Remove oil-water heat exchanger (1).
Installation note:
Replace profile gaskets (1).
Clean sealing faces (2):
On oil-water heat exchanger (3)
On full flow oil filter (4)
Vent cooling system.
RA Removing and installing, sealing or replacing full flow oil filter (M67)
BMW AG - TIS
10.02.2013 02:53
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -
