7 Series E38 740d (M67) SAL
Loosen screws (1).
Release retaining clip (2) on heat shield (3).
Remove heat shield (3) towards rear.
Unfasten cable clip (1).
Unclip battery positive lead (3) from cable holders (2).
Unscrew nut (1).
Tightening torque,
refer to Technical Data 12 41 4AZ.
Disconnect battery positive leads (2).
Unfasten cable clip (1).
Unclip battery positive lead from cable ties.
RA Removing and installing/replacing battery positive lead (between starter motor,
BMW AG - TIS
10.02.2013 03:24
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -