7 Series E38 740d (M67) SAL
Disconnect plug (1) from camshaft pulse generator.
Note:
For a better overview, this work step is shown without the
cable strip.
Disconnect all plug connections of engine wiring harness in V-
compartment.
Raise distributor housing of wiring harness (1) a little.
Disconnect plug on oil pressure switch.
Installation:
Read out fault memories of DDE control units.
Check stored fault messages.
Rectify faults.
Now clear the fault memory.
RA Replacing wiring harness section for engine (M67)
BMW AG - TIS
10.02.2013 03:28
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 7 -
