7 Series E38 750iL (M73) SAL
With height sensor:
Remove control arm on wheel carrier.
Installation:
Tapered pin and bore free of grease. Tightening torque,
refer to Technical Data 33 32 8AZ .
Unfasten shock absorber from wheel carrier.
Lift wheel carrier with jack and remove output shaft.
Installation:
Square head (1) on rubber mount points towards head of
screw.
Tightening torque,
refer to Technical Data 33 52 1AZ .
Installation:
Pull in output shaft using special tool
33 2 115 / 116 / 118.
RA Removing and installing or replacing output shaft
BMW AG - TIS
20.02.2013 22:03
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
