7 Series E65 735i (N62) SAL
Installation:
Replace seal (1).
Align gasket (1) loosely in cover groove. Starting at corner radii,
secure gasket (1) in cover groove and press into groove so that it
is free of tension.
Installation:
Replace spark plug domes.
Coat rubber seals on spark plug dome (1) with anti-friction rubber
coating.
Installation:
Install spark plug domes in cylinder head.
When fitting cylinder head cover:
Align spark plug domes to cylinder head cover.
Installation:
Clean seal residue from sealing surfaces.
Coat contact surfaces of joint with Drei Bond 1209 (refer
to BMW Parts Service).
RA Removing and installing/sealing left cylinder head cover (N62/N62TU)
BMW AG - TIS
08.02.2013 02:34
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
