7 Series E65 735i (N62) SAL
12 52 005
Removing and installing/replacing integrated
supply module (N62)
Note:
Read and print out fault memory with MoDiC or BMW DIS.
Switch off ignition.
Follow instructions for disconnecting and connecting battery.
Disconnect battery.
Caution!
Follow instructions for removing and installing electronic
control units.
Remove right fresh air duct.
Release screw and remove holder (1).
Release screws and remove cover (2) from control unit box.
Note:
Release screws on seal (3) only when removing wiring harness.
Installation:
Insert tabs (1) in openings (2) and close cover.
Unlock and detach plug connections on supply module (3).
Remove supply module (3).
RA Removing and installing/replacing integrated supply module (N62)
BMW AG - TIS
08.02.2013 04:04
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -