7 Series E65 735i (N62) SAL
12 14 550
Replacing control unit (Digital Motor
Electronics) (N62)
Switch off ignition.
Follow instructions for disconnecting and connecting battery.
Disconnect battery.
Caution!
Follow instructions for removing and installing electronic
control units.
Observe following instructions before replacing control unit:
·
Program control unit.
·
Code control unit.
Remove right fresh air duct.
Release screw and remove holder (1).
Release screws and remove cover (2) from control unit box.
Note:
Release screws on seal (3) only when removing wiring harness.
Installation:
Insert tabs (1) in openings (2) and close cover.
Unlock and detach plug connections on DME control unit (2).
Remove DME control unit (2).
RA Replacing control unit (Digital Motor Electronics) (N62)
BMW AG - TIS
08.02.2013 04:01
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
