7 Series E65 735i (N62) SAL
33 55 000
Removing and installing/replacing rear
stabilizer
Important!
Observe safety instructions on raising the vehicle.
Necessary preliminary tasks:
•
Remove complete rear axle carrier
•
Remove stabilizer link on both sides from stabilizer
Release screws (1).
Remove stabilizer (2).
Installation:
Check rubber mount on both sides, replace if necessary.
Tightening torque 33 55 3AZ
.
Replacement:
Remove rubber mount on both sides from stabilizer.
RA Removing and installing/replacing rear stabilizer
BMW AG - TIS
08.02.2013 07:57
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
