7 Series E65 735i (N62) SAL
Preparation of new part:
Mark severance cuts (1) on new part in accordance with previous severance cuts and cut.
Caution!
Cut outer plate only for following severance cuts.
Measurement a = approx. 330 mm above top door hinge mounting.
Measurement b = approx. 100 mm above severance cut (a).
Open weld joints on sheet panel (2) and remove component.
Installation:
Cut-out sheet panel (2) is needed again to seal B-pillar.
Open weld joints on outer entrance attachment (3) between severance cuts and remove component.
RA Replacing cover for longitudinal member with left or right door pillar (partial
BMW AG - TIS
08.02.2013 09:51
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
