7 Series E65 735i (N62) SAL
Move wipers into fold-back position:
-
Turn terminal "R" on and then immediately off again.
-
Press wiper lever upwards and keep pressed for approx.
3 seconds until wiper arms stop in roughly vertical position
(fold-back position).
-
Fold wiper arm away from windshield.
Note:
Complete spray nozzle consists of:
•
High-pressure nozzle
•
Washer fluid line
•
Multifunction element
The multifunction element acts as both the holder of the washer
fluid line and cover for the wiper arm.
Unlock high-pressure nozzle (1) and remove in direction of arrow.
Installation:
Make sure high-pressure nozzle (1) is correctly locked in wiper
arm.
Release locks of multifunction element (2).
Remove multifunction element (2).
Feed out distributor through opening on wiper arm.
Installation:
Make sure multifunction element (1) engages correctly in wiper
arm (2).
Fold wiper arm back onto windshield.
RA Removing and installing/replacing a jet nozzle in windshield washer system
BMW AG - TIS
08.02.2013 17:10
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
