7 Series E65 745i (N62) SAL
11 61 095
Removing and installing/replacing DISA
adjustment unit
Work step
Note:
Switch off ignition.
Remove design cover.
Remove engine cover.
Remove cover for ignition coils on left and right.
Remove bulkhead, equipment compartment, center.
Unlock plug on throttle and disconnect.
Unlock plug on knock sensor on left and right and disconnect.
Unlock plug on oil pressure switch and disconnect.
Unlock plug on thermostat and disconnect.
Unlock plug on water temperature sensor and disconnect.
Unlock plug on exhaust solenoid valve on left and right and disconnect.
Unlock plug on inlet solenoid valve on left and right and disconnect.
Unlock plug on tank venting valve and disconnect.
Unlock plug on alternator and disconnect.
Unlock plug on injection pipe on left and right and disconnect.
Unlock plug on Valvetronic servomotor on left and right and disconnect.
Unlock plug on exhaust camshaft sensor on left and right and disconnect.
Unlock plug on inlet camshaft sensor on left and right and disconnect.
Unlock plug on eccentric shaft sensor on left and right and disconnect.
Unlock plug on differential pressure sensor and disconnect.
Remove engine wiring harness from guides.
Release engine wiring harness screw connection to intake air manifold on left and
right.
The tasks listed above are described in the section "Wiring harness section for
engine".
Installation location:
Reverse side, intake air manifold.
Unlock plug (1) and disconnect from DISA adjustment unit (2)
(DISA = differentiated air intake system).
Unfasten screws.
Installation:
Replace screws.
Withdraw DISA adjustment unit (2) from intake air manifold.
Installation:
RA Removing and installing/replacing DISA adjustment unit
BMW AG - TIS
14.02.2013 03:44
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -