7 Series E65 750i (N62TU) SAL
Illustration shows E60/E61/E63/E64:
Perform filling operation slowly.
Pour coolant into expansion tank up to MAX mark.
Start engine and run at idle speed for approx. one minute (cap
open). Then adjust coolant level to MAX.
Close cap and run engine up to operating temperature until main
thermostat opens. Check cooling circuit and drain plug for leaks.
Important!
The engine must be cooled down before the coolant level is
checked. Coolant temperature must not exceed 30
°
C. If
ambient temperature is above 30
°
C, allow engine to cool
down to ambient temperature at least.
Check coolant level and adjust to MAX.
Note:
Do not fill coolant expansion tank over MAX level as overfilling will
cause the coolant to overflow.
RA Venting cooling system and checking for leaks (N62, N62TU)
BMW AG - TIS
16.02.2013 03:01
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
