7 Series E65 750i (N62TU) SAL
17 00 039
Venting cooling system and checking for
leaks (N62, N62TU)
Warning!
Danger of scalding!
Open sealing cap only after engine has cooled down.
No vent plugs on radiator and thermostat housing.
Cooling system is vented while it is filled and during subsequent
idle operation.
Note:
Before filling, turn on ignition. Set blower to low level. Seat heating
controller to maximum temperature. This ensures that the heater
valves are fully opened and the auxiliary water pump starts up.
Important: The auxiliary water pump must deliver coolant in order
to ensure fully venting!
Installation:
Use only recommended coolant.
Check cooling system for leaks.
Illustration shows E65/E66:
Perform filling operation slowly.
Pour coolant into expansion tank (1) up to MAX mark.
Start engine and run at idle speed for approx. one minute (cap
open). Then adjust coolant level to MAX.
Close cap and run engine up to operating temperature until main
thermostat opens. Check cooling circuit and drain plug for leaks.
RA Venting cooling system and checking for leaks (N62, N62TU)
BMW AG - TIS
16.02.2013 03:01
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
