7 Series E66 735Li (N62) SAL
Installing compression rings (1):
Important!
Plain compression rings (1) can easily break.
Carefully pull compression ring (1) apart and install from front.
Press compression ring (1) on one side into groove, install catch
on other side.
Insert inlet camshaft (1) so that cams point upwards at
cylinder 5 as shown in illustration.
Make sure bearing shells (1) of eccentric shaft are engaged in
bearing bracket.
Note:
Bearing shell (1) is guided in a groove in bearing cap.
Check dowel sleeves (1) for damage and correct installation
position.
RA Removing and installing/replacing left inlet camshaft (N62 to 9/03)
BMW AG - TIS
08.02.2013 17:33
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 9 -