X Series E53 X5 3.0d (M57) OFFRD
Installation:
Clean all sealing surfaces.
Replace profile seals (1) on oil filter housing (2).
Reassemble vehicle.
Start engine and run at idle until oil indicator lamp goes out.
Switch off engine, wait 10 minutes and then check engine oil level.
Top up engine oil if necessary.
Caution!
To avoid engine damage caused by coolant admixture in
engine oil:
It is absolutely essential after completing the tasks to drain off
the engine oil at the engine oil drain plug and change it.
Failure to comply with this procedure may result in serious
engine damage.
RA Removing and installing/sealing or replacing oil filter housing (M57)
BMW AG - TIS
03.02.2013 19:07
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
