X Series E53 X5 4.4i (M62) OFFRD
Remove left and right swivel bearings,
refer to 31 21 090.
Remove output shafts,
refer to 31 60 000.
Remove propeller shaft at front,
refer to 26 20 000.
Note:
To remove and install engine with exhaust manifold, you must
remove partition wall (3).
-
Unclip hose and cable, disconnect plug connection (1)
-
Feed out wiring harness (2)
-
Release nut and screws, remove partition wall (3)
Unfasten ground tape from right of engine support.
Unfasten top left and right nuts on engine mount.
Caution!
Only raise engine on locating lugs provided for this purpose.
Fit engine to special tool 11 0 000.
RA Removing and installing engine (M62)
BMW AG - TIS
08.02.2013 01:34
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -
