X Series E53 X5 4.4i (M62) OFFRD
Note:
The gasket is secured in a groove on the camshaft bearing
cover and over the non-return valve (1).
The non-return valve (1) is "inserted" in the cylinder head
and can fall out if the gasket is not fed out carefully.
Carefully feed out gasket.
If necessary, remove non-return valve.
Insert commercially available screw with M10x1 thread or special
tool 13 5 132 as and extraction aid by hand in non-return
valve (1) and carefully remove.
Installation:
Replace sealing ring (1) on non-return valve.
Caution!
Check installed direction.
An incorrectly installed non-return valve will result in engine
damage.
Install non-return valve with M10x1 thread facing outwards.
Installation
Installation of the camshaft adjustment unit distributor is described
separately from removal.
RA Removing and installing/replacing distributor on right camshaft adjustment unit
BMW AG - TIS
08.02.2013 02:14
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
