X Series E53 X5 4.4i (M62) OFFRD
Cut carpet (1) as illustrated and remove from car.
Installation:
Join cutting lines at marked points (2) with cable ties (short)
from repair kit.
Caution!
Vehicles with tire pressure control (RDC):
Unwind operational RDC lead from wiring harness.
Replace faulty RDC lead separately (refer to Electronic Parts
Catalog).
Cut through wiring harness (1) approx. 10 cm before splash
shield and pull back from inside into footwell.
Detach cut wiring harness from engine compartment and remove.
General information:
Information on assigning the repair connectors are contained in
the DIS under the heading Component and signal information /
pin, fan and solder connectors / connectors from X1... / X18985 -
X18992.
RA Replacing wiring harness at front left
BMW AG - TIS
08.02.2013 12:24
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
